|
停車場、地下車庫施工完環氧地坪后，都需要將道路、車位和指示箭頭用黃色的涂料標示出來，而且為了道路線和指示箭頭的耐用，以及對地面線路反光性能的要求，一般使用熱熔涂料畫線。<\/span> <\/p> <\/span>熱熔標線涂料屬于熔融型涂，當溫度達到180—220℃<\/span>時，涂料就變成粘稠的流動狀態，常溫下就變成固態。在把熱熔涂料涂敷于路面的同時撒上玻璃珠，就可以讓熱熔涂料標示的道路線具有反光性能，在停電的情況下，只要車頭燈照射依舊明顯可見。提高地下車庫下行車的安全性。<\/span><\/span> <\/p> <\/span><\/span><\/span> <\/p> 使用注意事項：<\/span><\/span> <\/p> <\/span><\/span>一、<\/span> <\/span><\/span>儲存<\/span><\/span> <\/p> 1<\/span><\/span>、疊放層次不宜過高，一般以八層為宜<\/span>;<\/span><\/span><\/span> <\/p> 2<\/span><\/span>、存放時間不宜過長，一般以三個月內使用**，超過半年品質將受影響（如顏色變黃，軟化點升高，材質塑性下降等）。<\/span><\/span> <\/p> <\/span><\/span>二、<\/span> <\/span><\/span>煮料<\/span><\/span> <\/p> 1<\/span><\/span>、<\/span> <\/span><\/span>嚴格控制好煮料溫度，一般在<\/span>180<\/span><\/span>°<\/span>C-220<\/span><\/span>°<\/span>C,<\/span><\/span>嚴禁超過<\/span>220<\/span><\/span>°<\/span>C<\/span><\/span>；<\/span><\/span> <\/p> 2<\/span><\/span>、注意熱熔釜的攪拌功能，一定要充分攪拌才能出料；<\/span><\/span> <\/p> 3<\/span><\/span>、嚴禁不同廠家和不同顏色的涂料混合使用。<\/span><\/span> <\/p> 三、<\/span> <\/span><\/span>路面狀況<\/span><\/span> <\/p> 1<\/span><\/span>、<\/span> <\/span><\/span>路面必須清潔干凈，無舊線、油污和其他污垢物，同時保持干燥無濕度；<\/span><\/span> <\/p> 2<\/span><\/span>、路面溫度應高于<\/span>10<\/span><\/span>°<\/span>C<\/span><\/span>以上方可施工；<\/span><\/span> <\/p> 3<\/span><\/span>、除新瀝青路面，其他路面必須涂布底漆；<\/span><\/span> <\/p> 4<\/span><\/span>、<\/span> <\/span><\/span>新的水泥路面一定要使用三個月以上才可施工。<\/span><\/span> <\/p> <\/span><\/span>四、<\/span> <\/span><\/span>施工過程<\/span><\/span> <\/p> 1<\/span><\/span>、注意檢驗涂料、底漆和路面之間的粘結力，每個工作日**取三次試樣；<\/span><\/span> <\/p> 2<\/span><\/span>、注意反光玻璃珠的附著情況和反光效果，適時調整涂料的溫度；<\/span><\/span> <\/p> 3<\/span><\/span>、注意標線的顏色效果，若有白色變黃，黃色變綠的現象，應立即降低熱熔釜溫度，直到恢復正常。<\/span><\/span> <\/p> <\/span><\/span> <\/p> 五、<\/span> <\/span><\/span>涂料用量<\/span><\/span> <\/p> 1<\/span><\/span>、水泥路面，涂膜厚度<\/span>1.8mm,<\/span><\/span>每平方用料<\/span>5<\/span><\/span>公斤左右；<\/span><\/span> <\/p> 2<\/span><\/span>、<\/span> <\/span><\/span>瀝青路面，涂膜厚度<\/span>1.8mm,<\/span><\/span>每平方用料<\/span>5.5<\/span><\/span>公斤左右；<\/span><\/span> <\/p> 3<\/span><\/span>、每平方玻璃珠用量<\/span>0.25<\/span><\/span>公斤左右；<\/span><\/span> <\/p> 4<\/span><\/span>、每平方底漆用量<\/span>0.2<\/span><\/span>公斤左右。<\/span><\/span> <\/p> <\/span><\/span>六、<\/span> <\/span><\/span>標線的完好率<\/span><\/span> <\/p> 1<\/span><\/span>、<\/span> <\/span><\/span>標線剛施工完驗收時，完好率應達<\/span>99%<\/span><\/span>以上；<\/span><\/span> <\/p> 2<\/span><\/span>、標線使用半年內，完好率應保持<\/span>90%<\/span><\/span>以上；<\/span><\/span> <\/p> 3<\/span><\/span>、標線使用一年以內，完好率應保持<\/span>75%<\/span><\/span>以上；<\/span><\/span> <\/p> <\/span><\/span>停車場：熱熔標線<\/span>,<\/span><\/span>反光標線<\/span>,<\/span><\/span>振蕩標線<\/span>,<\/span><\/span>車位線<\/span>,<\/span><\/span>劃線<\/span>,<\/span><\/span>斑馬線<\/span>,<\/span><\/span>停車線<\/span> |
在線咨詢 
